Check the composition and whether the manufacturer allows damp cleaning.

Look at the visor, front, reinforcements, and any delicate patch or detail.

Test diluted soap first on a discreet area, especially on dark colors.

Materiales: solo lo necesario

Cold or slightly warm water (if the label allows), a little mild soap without bleach, a microfiber cloth, a soft-bristle brush, and a clean towel.

Empieza en seco

Remove dust with a soft brush or clean cloth. That way you avoid dragging it when you start dampening the fabric.

Treat stains first

Apply a small amount of diluted mild soap with a barely damp cloth. Use dabbing or short strokes without rubbing hard.

Si no desaparece: rinse off the soap, check that the fabric has not changed, and repeat gently if it is safe.

Dedica tiempo a la banda interior

This is the part in contact with your forehead and often collects sweat and oil. Clean it with a very soft cloth or brush and diluted soap.

Importante: work only the band; there is no need to soak the crown or visor.

Clean the exterior without pressing

Work panel by panel with a lightly damp cloth or brush. Follow the direction of the fabric and avoid pressing repeatedly on the same spot.

On our Essentials y Heritage Club, pay attention to the seams and clean around the embroidery gently.

On the visor, use very little moisture

Pass a lightly damp cloth over both sides without folding or twisting it. If you do not know the inner material, avoid soaking it completely.

Rinse the soap well

Pass another clean cloth dampened with water only. Repeat as many times as needed to remove residue without saturating the cap.

You do not need to put it under a strong stream of water to rinse it.

Start with the inner band and treat visible marks with diluted mild soap after checking that it does not affect the color.

Repeat spot cleaning if the fabric tolerates it. Not every stain comes out: avoid rubbing harder to force it.

Clean the inner band especially and let the cap dry completely before storing it.